Friday, September 27, 2019

Foscam Set Alarm Record Path






I am no longer able to record to a set path (set the alarm path fail!). it defaults to a c:userspublicdocuments. i have updated trusted sites and local internet. the path i want to push to is still not set to private. i had recently updated the firmware and windows 10 pushed an update.. Record path is used to store manual record, alarm record path is used to save automatic record. q: i set remote settings according the guide, but still cannot login the camera in internet, why? a: firstly, make sure if the following settings are correct.. When i change the record path, it shows “set record path failed”? if camera shows this error, it may due to the security settings of your os; you can add the camera’s ip address as a trusted site to resolve this issue..












When you record, you need open the monitoring system ui. if you close the real-time ip camera monitoring system, camera will stop recording. if you want to change record path, please go to “user settings” to set. record path is used to store manual record, alarm record path is used to save automatic record. comments. comments. Upload image on alarm – this setting allows you to upload images using the ftp settings you have set in ftp service settings. you can set the upload interval here as well in seconds. support@foscam.us page | 42 1-800-930-0949... page 44. you can click “set all” at the top of the scheduler to set motion detection to all the zones easily.. It appears to record, i save and then can't see the file. if i record again, when i goto save i can see the previous saved file and it's size, but, again after saving can't see it to open. i know the folder where it is supposed to be. i'm using win7 with ie, so active x . contacting foscam support they are now suggesting i use vlc..



foscam set alarm record path

visit link reference



0 comments:

Post a Comment

Note: Only a member of this blog may post a comment.